Chuyển đến nội dung
Công ty TNHH VietMobEmpowering Vietnam Mobility

Router Draytek Vigor IPPBX 3510

Thương hiệuDraytek Tình trạngCòn hàng

Liên hệ

  • – PBX & SIP server, Load Balancing router
  • Danh mục: Thẻ: Thương hiệu:

    Mô tả

    Đặc tính kỹ thuật của VigorIPPBX 3510

    Hardware Interface LAN 4-port 10/100 LAN, RJ-45
    VigorIPPBX 3510 WAN 1-port 10/100 WAN, RJ-45
      USB 1-port USB host 2.0 for storage
      VoIP  4-port FXS module
      (2-port Interface card slot) 4-port FXO module
        S0/TE module *
        ALL TE module *
      Reset 1 Factory reset button
    IP PBX Features 6 IP accounts
    100 accounts (extensions)
    Registration and authentication
    1 levels AA
    Hunting group (10)
    IVR
    Time Scheduling
    Dial plan (digi-map)
    Session monitor
    Call detail records
    DID
    Extension privilege assign
    PIN code control
    Call barring
    Call routing
    Call park
    Call pickup
    Call forwarding
    Call transfer
    In/Out band call through FXO interface
    User defined prompts
    Voice message to e-mail
    Voice mail
    MWI
    Music on hold
    1 conference bridge *
    ISDN features ISDN Failover (Loop through) [available on 2 TE/NT(S0) interface module]
    ISDN On-Net/Off-Net
    10 MSN (Multiple Subscriber Numbers) on each ISDN S0 port for VoIP Call
    Signaling compliance : ITU-T Rec. Q. 920, Q921, Q930, Q931
    FAX/Modem support Tone detection
    G.711 pass-through
    T.38 for FAX
    WAN protocol Ethernet PPPoE, PPTP, DHCP client, static IP, L2TP, BPA
    ISDN DSS1 (Euro ISDN), PPP, ML-PPP(64/128Kbps)
    Dual WAN Outbound policy based Load balance Allow your local network to access Internet using multiple INternet connections with high-level of Internet connectivity availability
    Two dedicated Ethernet WAN ports (10/100Mb/s)
    WAN fail-over or load-balanced connectivity
    Bandwidth on Demand Service/IP based preference rules or auto-weight
    VPN Protocols PPTP, IPSec, L2TP, L2TP over IPSec
    Up to 32 sessions simultaneously LAN to LAN, remote access (teleworker-to-LAN). doa;-in or dial-out
    VPN throughput 50Mbps
    NAT-Traversal (NAT-T) VPN over routes without VPN pass-through
    PKI certificate Digital signature (X.509)
    IKE authentication Pre-shared key; IKE phase 1 aggressive/standard modes & phase 2 selectable lifetimes
    Authentication Hardware-based MD5, SHA-1
    Encryption MPPE and hardware-based AES/DES/3DES
    RADIUS client Authentication for PPTP remote dial-in
    DHCP over IPSec Because DrayTek add a virtual NIC on the PC, thus, while connecting to the server via IPSec tunnel, PC will obtain an IP address from the remote side through DHCP protocol, which is quite similar with PPTP
    Dead Peer Detection (DPD) When there is traffic between the peers, it is not necessary for one peer to send a keep-alive to check for liveness of the peer because the IPSec traffic serves as implicit proof of the availability of the peer
    Smart VPN software utility Provided free of charge for teleworker convenience (Windows environment)
    Easy of adoption No additional client or remote site licensing required
    Industrial-standard interoperability Compatible with other leading 3rd part vendor VPN devices
    Content filter URL keyword blocking Whitelist and Blacklist
    Java applet, cookies, active X, compressed, executable, multimedia file blocking
    Web content filter Dynamic URL filtering database
    Time schedule control Set rule according to your specific office hours
    Firewall Stateful Packet Inspection Outgoing/Incoming traffic inspection based on connection information
    VigorIPPBX 3510 Content Security Management Appliance-based gateway security and content filtering
      Multi-NAT You have been allocated multiple public IP address by your ISP. You hence can have a one-to-one relationship between a public IP address and an internal/private IP address. This means that you have the protection of NAT (see earlier) but the PC can be addressed directly from the outside world by its aliased public IP address, but still by only opening specific ports to it (for example TCP port 80 for an http/web server)
      Port redirection The packet is forwarded to a specific local PC if the port number matches with the defined port number. You can also translate the external port to another port locally
      Open ports As port redirection (above) but allows you to defined a range of ports
      DMZ host This opens up a single PC completely. All incoming packets will be forwarded onto the PC with the local IP address you set. The only exceptions are packets received in response to outgoing requests from other local PCs or incoming packets which match rules in the other two methods.
      The precedence is as follows : Port Redirection > Open Ports > DMZ
      Policy-based IP packet filter The header information of an IP packet (IP or Mac source/destination addresses; source/destination ports DiffServ attribute; direction dependent, bandwidth dependent, remote-site dependent
      DoS/DDoS prevention Act of preventing customers, users, clients or other computer from accessing data on a computer
      IP address anti-spoofing Source IP address check on all interface: only IP addresses classified within the defined IP networks are allowed
      Object-based firewall Utilizes object-oriented approach to firewall policy
      Notification E-mail alert and logging via syslog
      Bind IP to MAC address Flexible DHCP with ‘IP-MAC binding’
      WDS security The us of authentication and encryption techniques on a Wireless Distribution System (WDS) link between compatible access points
    System management Web-based user interface (HTTP/HTTPS) Integrated web server for the configuration of routers via Internet browsers with HTTP or HTTPS
    DrayTek’s Quick Start Wizard Let administrator adjust time zone and promptly set up the Internet (PPPoE, PPTP, Static IP, DHCP)
    User administration RADIUS user administration for dial-in access (PPP/PPTP and ISDN CLIP)
    CLI (Command Line Interface, Telnet/SSH) Remotely administer computers via the telnet
    DHCP client/relay/server Provides an easy-to configure function for your local IP network
    Dynamic DNS When you connect to your ISP, by broadband or ISDN you are normally allocated an dynamic IP address. i.e. the public IP address your router is allocated changes each time you connect to the ISP. If you want to run a local server, remote users cannot predict your current IP address to find you
    Administration access control The password can be applied to authentication of administrators
    Configuration backup/restore If the hardware breaks down, you can recover the failed system within an acceptable time. Through TFTP, the effective way is to backup and restore configuration between remote hosts.
    Port-based VLAN Create separate groups of users via segmenting each of the Ethernet ports. Hence, they can or can’t communicate with users in other segments, as required
    Built-in diagnostic function Dial-out trigger, routing table, ARP cache table, DHCP table, NAT sessions table, wireless VLAN online station table, data flow monitor, traffic graph, ping diagnosis, trace route
    NTP client/call scheduling The Vigor has real time clock which can update itself from your browser manually or more conveniently automatically from an Internet time server (NTP). This enables you to schedule the router to dial-out to the Internet at a preset time, or restrict Internet access to certain hours. A schedule can also be applied to LAN-to-LAN profiles (VPN or direct dial) or some of the content filtering options
    Firmware upgrade via TFTP/HTTP/FTP Using the TFTP server and the firmware upgrade utility software, you man easily upgrade to the latest firmware whenever enhanced features are added
    ISDN remote maintenance The system manager can remotely manage the routers through an ISDN remote dial-in with secure call back mechanism
    Remote maintenance With Telnet/SSL, SSH (with password or public key), browser (HTTP/HTTPS), TFTP or SNMP, firmware upgrade via HTTP/HTTPS of TFTP
    Wake on LAN A PC on LAN can be woken up from an idle/stand by state by the router it connects when it receives a special ‘wake up’ packet on its Ethernet interface
    Logging via syslog Syslog is a method of logging router activity
    SNMP management Tag: VigorIPPBX3510